Long-lifetime water-washable ceramic catalyst filter for air purification.

Particulate matter (PM) and volatile organic compounds (VOCs) are recognised as hazardous air pollutants threatening human health. Disposable filters are generally used for air purification despite frequent replacement and waste generation problems. However, the development of a novel regenerable and robust filter for long-term use is a huge challenge. Here, we report on a new class of facile water-washing regenerable ceramic catalyst filters (CCFs), developed to simultaneously remove PM (>95%) and VOCs (>82%) in single-pass and maximized space efficiency by coating the inner and outer filter channels with an inorganic membrane and a Cu2O/TiO2 photocatalyst, respectively. The CCFs reveal four-fold increase in the maximum dust loading capacity (approximately 20 g/L) in relation to conventional filters (5 g/L), and can be reused after ten regeneration capability with simple water washing retaining initial PM and VOC removal performances. Thus, the CCFs can be well-suited for indoor and outdoor air purification for 20 years, which shows a huge increase in lifetime compared to the 6-month lifespan of conventional filters. Finally, we believe that the development and implementation of CCFs for air purification can open new avenues for sustainable technology through renewability and zero-waste generation.

Pilot Scale Hybrid Organic/Inorganic Coatings on a Polyolefin Separator to Enhance Dimensional Stability for Thermally Stable Long-Life Rechargeable Batteries.

The electric vehicle and energy storage markets have grown rapidly in recent years. Thermal runaway caused by malfunctioning Li-ion batteries is an urgent issue with many causes (e.g., mechanical, electrical, and thermal abuse). The most common cause of thermal runaway is the formation of an internal short circuit because of damage to the separator. There has been significant effort to improve the design of separators, but to our knowledge, only inorganic nanoparticle coatings are used in commercial Li-ion batteries. Here, hybrid organic/inorganic coating layers are synthesized in a pilot-scale process that was developed from a crosslinkable polyamide-imide synthesis technique. The fabrication process is optimized to achieve reproducible hybrid organic/inorganic coating layers that are thin (≤4 µm), permeable (≤250 s/100 cc), and thermally stable beyond 150 °C. The hybrid coating layer is applied to mini-18650 Li-ion cells to show that the discharge capacity did not change at low discharge rates, and the retention capacity after 500 cycles was better than that of the reference cells used for comparison. This work demonstrates that a novel hybrid coating layer has the potential to improve the stability of commercial Li-ion batteries.

Aqueous production of secondary organic aerosol from fossil-fuel emissions in winter Beijing haze.

Secondary organic aerosol (SOA) produced by atmospheric oxidation of primary emitted precursors is a major contributor to fine particulate matter (PM2.5) air pollution worldwide. Observations during winter haze pollution episodes in urban China show that most of this SOA originates from fossil-fuel combustion but the chemical mechanisms involved are unclear. Here we report field observations in a Beijing winter haze event that reveal fast aqueous-phase conversion of fossil-fuel primary organic aerosol (POA) to SOA at high relative humidity. Analyses of aerosol mass spectra and elemental ratios indicate that ring-breaking oxidation of POA aromatic species, leading to functionalization as carbonyls and carboxylic acids, may serve as the dominant mechanism for this SOA formation. A POA origin for SOA could explain why SOA has been decreasing over the 2013-2018 period in response to POA emission controls even as emissions of volatile organic compounds (VOCs) have remained flat.